Sandblast Glass Shield

Leadbitter Glass now offer our sandblasted glass protection product free with all single glazed etched glass panels. Once the glass has been sandblasted or etched, grease marks left by fingers can leave an annoying appearance to the etched areas of the glass. Our Sandblast Protection process will protect the etched areas of the glass and help keep the etched glass panel looking as good as new.

During the sandblasting process, glass is placed into a sandblasting booth and a coarse grit is blasted at high pressure against the glass surface to give it that 'etched' finish. When this happens, microscopic pockets are created in the glass surface and dirt and grease from fingers can come to rest in these areas of the glass once the glass has been handled. When this happens it can be almost impossible to fully remove these marks from the etched glass but our sandblast protection shield is the perfect solution.

Our clear sandblast protection shield is applied to the whole area of the glass after the sandblasting process and this gives all of the etched areas a protective coating that eradicates most types of permanent marks. Almost all of the etched glass supplied by Leadbitter Glass is created for glass sealed units so the protection is not needed as the etched area of the glass is encased inside of the sealed unit. If you are ordering single glazed etched/sandblasted glass from Leadbitter Glass, you will now receive this product free of charge to help protect your beautiful new decorative glass panels.

Make sure that if you are ordering etched glass that is not supplied by the Leadbitter Glass studio, you are not going to be charged for the sandblast protection on top of your quoted price!